Like having two radios in one, the dual receive function allows you to receive and listen to two different channels simultaneously
Brand :Oricom
An Australian First!
Like having two radios in one, the dual receive function allows you to receive and listen to two different channels simultaneously without compromising the regular features you’d expect from a UHF CB Radio. Perfect radio for any vehicle where space is limited.
Simply, install the transceiver out-of-sight as the full functional ergonomic controller speaker mic has all you’ll need to stay connected on and off road.
The DTX4200 recently featured on both 'What's Up Down Under'
GENERAL | DTX4200 |
Compliance | AS/NZS 4365:2011 |
Frequency Range TX/RX | 476.425 - 477.4125 MHz |
Number of TX/RX Channels | 80 UHF CB Channels (75 voice) |
Channel Spacing TX/RX | 12.5KHz |
Operating modes | Simplex, Repeater TX offset (+750KHz) |
Scanning Speed | 50 msec per channel |
Antenna Impedance | 50 Ohms |
Operating Volts nominal | 13.8VDC to 28VDC |
Operating Volts Range | 10 to 30VDC |
Over Voltage Protection | Diode and Voltage regulator system |
Over Current Protection | 2 AMP fuse |
Reverse Polarity Protection | Shunt diode |
Frequency stability | +/- 5 ppm |
TRANSMITTER | |
RF Output Power | 5 watts max |
Modulation | F3E(FM) |
Maximum deviation | 2.5KHz |
Spurious Emissions | < -30dBm |
TX Audio pre-emphasis | +6dB/Octave from 300Hz to 3KHz |
Current consumption during TX | 1.7 AMP with 50 ohm antenna termination |
RECEIVER | |
Circuit Type | Dual conversion super heterodyne |
Intermediate Frequencies | 1st IF: 21.4MHz, 2nd IF: 450KHz for Main RX |
Maximum usable sensitivity | - 123dBm for 12dB SINAD (receiver sensitivity) |
Audio output power | > 2 Watts at 8 ohm load |
RX Audio de-emphasis | +6dB/Octave from 300Hz to 3KHz |
Signal to Noise Ratio | > 40dB |
Conducted Spurious Emission | > -57dBm |
MECHANICAL | |
Dimensions (H) X (W) X (D) | 31 x 128 x 147 |
Weight | 548g transceiver / 200g controller speaker mic |