Track Bar Reinforcement & Sector Shaft Brace Suitable For Jeep JK & JKU Wrangler 2007-2018 Right Hand Drive

Strengthen the steering and track bar mount on your Wrangler with this right hand drive specific no drill, no weld solution for wallowed track bar holes.

Brand :Tough Toys

$500.00 AUD

or 4 payments of $125.00 with
Paypal

Learn More
or 4 payments of $125.00 with
Afterpay

Learn More

Description

Using your 2007- 2018 JK/ JKU Wrangler for its intended purpose offroad can cause additional stress on your steering components. Ultimately the addition of big tyres cause loose and worn steering components. By installing the bolt on 6mm thick steel Tough Toys - Track Bar Bracket Reinforcement & Sector Shaft Brace on your JK/ JKU you can repair and reinforce the chassis-side track bar bracket and get back to off-roading sooner with the confidence that your steering components are secure and stronger than OEM forgetting your worries about death wobble!

Using 6mm thick steel, the Tough Toys - Track Bar Bracket Reinforcement & Sector Shaft Brace is a bolt on solution to encompass the OEM track bar bracket on the chassis of your JK/JKU Jeep Wrangler 2007-2018.

It serves two purposes:

The prevention or repair of oval (wallowed out) holes on the OEM chassis-side track bar bracket by providing a tight fit hole and partially threaded bolt with fully shanked section riding on both mounting holes. This is a common cause of what’s known as “death wobble”. The chassis track bar bracket is also reinforced for the extreme stress experienced when off-roading.
By utilizing a longer nut with shoulder for the sector shaft the design creates a double shear configuration when combined with a bearing installed in a block mounted under the steering box. This design enhances steering box longevity and stability, especially with larger tires.

Features:

Automotive engineer approved
No weld, no cut, no drill installation - completely bolt on
6mm wall laser-cut and fully welded bracket
12mm thick sector shaft brace with replaceable sealed roller bearing
Upgraded track bar flange bolt and nut
Powder coated for corrosion resistance
100% Australian made

Suits the following vehicles:

2007-2018 Jeep Wrangler JK / JKU

This product has been approved as a suitable upgrade for Jeep Wrangler vehicles by a nationally approved automotive engineer based on engineering drawings provided, applied load calculations and practical inspection of a panhard brace fitted to a vehicle. See the JK Wrangler Track Bar Reinforcement and Sector Shaft Brace Engineer's Report here.

See the Track Bar Bracket Reinforcement & Sector Shaft Brace Installation Instructions here.

Note:
Only works with OEM steering box.
Do NOT install this product if there is pre-existing play in the steering box sector shaft. Rebuild or replace the steering box first!

NOTE

We strongly recommend having vehicle accessories products installed by a professional workshop for the best results and to ensure proper operation.

Additionally, please be aware that the installation of aftermarket modifications to your vehicle may affect its compliance with local road use regulations. We advise you to consult with your local authorities and verify the necessary certification or compliance requirements to remain legal for on-road use of your vehicle.